Making a lamp from a vintage vase is a quirky doit-yourself task that lights up your room in a one-of-a kind way. You will need to insert a rod and lighting-fixture to the body of the vase to create a porcelain vase right into a lamp. While the opening of the vase normally accommodates fixture and the rod, youare going to need to drill a hole to to operate a lamp cord from the side of the vase, but you can not use to drill through porcelain.
Clean the the top of vase carefully. Wipe it down using a clean, lint-free cloth dampened with white vinegar and then a cloth dampened with water. Dry the area using paper towels or a cloth.
Secure the vase into a surface, like a function table. Tape it leaving the region you want to drill up right side. You will want to enable as little motion as possible.
Put a bit of masking tape on the the location you want to drill. Mark marker to to point your goal or the tape using a pencil.
Equip your electric drill using a carbide-tipped masonry drill bit. Use a size suitable for the diameter of the cord you program to tell you the vase.
Set the drill into a low speed environment. Align the bit with all the mark you made on the tape and drill gradually, maintaining your hand as well as the bit vertical as constant as possible. Take your time â in case the bit gets hotter, wet it somewhat using a water-dampened sponge and carry on drilling before you’ve the proper-sized hole.
Remove the drill bit in the hole, as you pull it out — maintaining the bit vertical — not slanted. Remove the tape in the vase and use the moist sponge to clear any porcelain dirt in the work and vase location.
Sand the rim of the hole utilizing a tiny bit of great-grit sand-paper. Wipe a-way any left-over dirt with all the sponge.