Oil needs vary by manufacturer, model and parts of the series saw. To get a Homelite Super 2 series saw, two different types of oils are required: one for the engine and one for the series. If petroleum specifications are neglected, the saw can malfunction.
Homelite chain saws are equipped with lookup engines. Use only oil specified for search motors. Homelite generates its own brand of lookup engine optimization that should be used for best results. If Homelite oil isn’t available, use other good quality lookup engine oil, but think about adding an ethanol gas stabilizer to the fuel to prolong the freshness of this mix — Homelite oils come with a fuel stabilizer already mixed in.
Engine oil ought to be mixed with gasoline at a predetermined ratio before fueling the machine. When refueling with Homelite oil, combine oil with unleaded gasoline at a ratio specified on the container. For other two-stroke engine oils, Homelite recommends mixing one part acrylic with 16 parts gas. Pay careful attention the mix, because not enough oil can cause the engine to overheat, while excess oil can slow down the chain found.
Use caution when mixing fuel. Mix at a tidy, gasoline-safe container to assure the fuel is well mixed before pouring it into the engine. Failing to combine thoroughly can feed either too much gasoline or petroleum at once to the engine, which can cause malfunctions. Also, as gas and oil naturally separate, prevent mixing considerable quantities of fuel at once.
The Super 2 series needs to stay lubricated to operate . This chain is fed by a separate, automatic oil pump. The perfect oil for a Super 2 chain is Homelite Bar and Chain Oil. Clean SAE 30 oil can also be used to lubricate the chain, based on Homelite. If the temperature is below 40 degrees Fahrenheit, it is possible to dilute the SAE 30 oil with kerosene.